The access method is how the crew gets water to the wall: from the ground, from a boom lift, from a rope crew, or from a drone. Height tells you which methods are possible. The site tells you which one fits. What sits at the base of the wall, what hangs over it, what flies near it, what the wall is made of, and who walks past it all day usually decide the method.
Key Takeaways
- Two buildings of the same height can need different access methods because their sites are different
- A boom lift needs firm, level ground close to the wall. Lawns, planting beds and busy sidewalks work against it
- A rope crew needs roof anchors above each wall and a clear drop zone below it
- A drone needs open air near the wall and a spot for our ground equipment, and it only flies from 30 minutes before sunrise to 30 minutes after sunset
- The surface sets how we clean. The site sets how we reach it. Keep the two decisions apart
Height Narrows the List. The Site Picks the Method.
Most advice on building cleaning starts with height and stops there. Height does matter. From the ground, a crew with a pressure washer and a water-fed pole can clean the lower floors. Above that you need a boom lift, a rope crew or a drone. On rare jobs, scaffolding is also on the list.
But height only tells you which methods are possible. Two four-story buildings can need different methods. One sits behind a wide lawn with a parking lot on every side. The other sits on a Center City sidewalk with power lines out front. The site picks the method.
This page covers the site conditions we check on every walk. If you want the cost and speed comparison of each method, read our drone vs boom lift vs rope access guide. For high-rise glass, including building gondolas, read our high-rise window cleaning comparison.
See also: Drone vs Boom Lift vs Rope Access: Cost · High-Rise Window Cleaning: BMU, Rope or Drone
Sidewalks and Street Frontage
A boom lift has to park at the base of the wall. On a suburban office park that is a parking lot. On a city block it is a public sidewalk, and sometimes a parking lane too. The lift blocks that space for as long as the job runs, and people still need a safe way past.
A rope crew also needs the ground below. Water and cleaning solution come down the wall, so the area under each drop is marked off while the crew works it.
With a drone, our ground equipment sits at the curb, in a loading area or in the lot. We still mark off the area under the spray so people walk around it. But no lift sits on the sidewalk, and on most buildings the setup takes under an hour.
Landscaping and Soft Ground
Boom lifts are heavy. On a lawn they can leave ruts. On planting beds they cannot go at all without crushing what is there. On pavers, or on a parking deck over a garage, ask the building engineer if the surface can take the weight before anyone brings a lift in.
Deep beds and hedges along a wall also push a lift further back. The further back it parks, the more of its reach goes to getting across the beds, and the less is left for height.
A drone crosses the beds in the air. The only thing on the ground is the hose from our ground equipment. When we soft wash near plants, we wet them first and rinse them after, whatever the access method.
Setbacks, Courtyards and Lower Roofs
A setback is the distance between the place equipment can stand and the wall it has to clean. Many buildings have upper floors set back from the floors below, a wall that faces an inside courtyard, or a lower roof in front of a taller wall. Each one puts the wall further from the ground.
A lift has to reach out and up at the same time, so a wide setback can put the top of a wall out of reach. A rope crew needs an anchor point above each drop and a straight drop to the ground, and a setback breaks that line. A drone flies to the wall, so setbacks matter less. Deep recesses and long overhangs can still need a second method for that part of the building.
Lower roofs are part of this decision too. If the lower roof has a low slope, we clean it with the drone. If it is flat, our crew works from the roof itself.
Overhead Wires and Trees
Power lines along the street side limit where a lift can raise its boom. They also limit where a drone can fly. We check where the wires run on each wall. A wire run along one face can push that face to a different method than the rest of the building.
Mature trees cause the same kind of problem. Branches can block a lift's boom path and a drone's flight path. Sometimes we can spray that section from a different angle. Sometimes the section under the canopy is better cleaned from the ground or a lift.
Airspace and Flight Hours
Every drone job is flown by an FAA Part 107 certified pilot. Near an airport or a heliport, including hospital helipads, the flight also needs FAA airspace authorization before work starts. We check this before we schedule the job, not on the day of the job.
The drone only flies from 30 minutes before sunrise to 30 minutes after sunset. That matters for buildings that want work done overnight. Ground work can happen at night if the client wants it. Drone work cannot.
On a standard setup the drone reaches about 190 feet, which is about 15 stories. A tethered hose takes weight off the drone so it can go higher. On buildings above 15 stories we meet with you and walk the site first.
The Surface Decides the Cleaning
How we reach a wall and how we clean it are two separate decisions. The surface decides the cleaning. The site decides the access.
We soft wash stucco, EIFS and painted surfaces: a cleaning solution at low pressure, then a rinse. On brick, concrete and stone we start at low pressure, then go to medium. High pressure can damage a surface, so it is a last resort.
Glass is either soft washed or pressure washed, depending on the type of glass. The pressure wash uses pressurized deionized water, so the glass dries without spots, and we never go above about 2,500 PSI on windows. A lift basket working close to glass can also scratch it, which is one more reason to look at a drone on a glass facade.
See also: Soft Washing vs Pressure Washing
Tenant and Foot Traffic
Who uses the building changes how long each method can block the site. A retail entrance cannot be closed during open hours. A medical office needs its accessible route open all day. A hotel needs a clear arrival area, so we usually clean hotels early in the week, after 10 AM.
A lift that stays at the main entrance for several days is a real problem on these sites. A drone job is often faster, which shortens the time any one entrance is affected. On every method, we plan the work zone around entrances, loading docks and outdoor seating, and tell you in advance which areas will be closed and when.
When One Building Needs Two Methods
Many buildings need more than one method. A tower over a row of storefronts is a common example: the drone cleans the tower, and a ground crew cleans the storefronts. We work top-down, so the drone goes first and the water-fed pole on floors one and two goes last. That way, dirty water from above never runs onto glass we already cleaned.
When a job would otherwise need a boom lift or a rope crew, we can often pass 30 to 50 percent in savings on to the customer, depending on the condition of the building. On buildings the ground crew can reach, the ground crew is usually the simplest choice.
See also: Drone Cleaning Services · Building Facade Washing
What We Check on the Site Walk
On a site walk we go around every wall and note the ground at its base, what hangs over it, how far equipment can get from it, what it is made of, and who uses the area in front of it. We also check airspace before we pick a method. The proposal then names the access method for each wall and the reason for it.
After the job, our crew walks the site with you to confirm every wall is clean. Call (610) 981-2285 or request a quote to set up a site walk.
See also: Commercial Exterior Cleaning Scope Walk · Request a Quote
