Back to Home
WashLabs
Learn 5 min read

Copper Roof Cleaning by Drone: Distillery Case Study

A copper roof on a Columbus, Ohio whiskey distillery had gone almost black. How we cleaned it by drone in one afternoon, with photos from the job.

By Sean Stone, Co-Founder, WashLabsUpdated November 2, 2026

In October 2026 we cleaned the copper roof on the tower of Middle West Spirits, the Columbus, Ohio distillery that makes OYO whiskey. The building is fairly new, but the copper had already oxidized to almost black. We washed it by drone in one afternoon.

Key Takeaways

  • Client: Middle West Spirits (OYO whiskey), production plant tower, Columbus, Ohio
  • Date: Friday, October 23, 2026
  • Surface: standing-seam copper roof, oxidized from bright copper to almost black
  • Method: drone soft wash, with the solution fed up a hose from our ground equipment
  • Time: one afternoon. Bright copper showed after the first pass.

The problem: a new copper roof that looked old

Middle West Spirits makes OYO whiskey in Columbus. Its production plant has a tower with a standing-seam copper roof. When we arrived, most of that roof was dark brown to almost black.

That is not dirt, and it is not damage. Copper oxidizes. New copper is bright, like a penny. Within months the first oxide turns it reddish brown, and over the next few years it can go dark brown and then almost black. The green patina most people expect comes much later. In a moderate climate it can take 15 to 20 years.

The owner wanted the copper color back.

Standing-seam copper roof on a distillery tower in Columbus, Ohio, oxidized almost black before cleaning
The tower roof before cleaning. Drone still, October 23, 2026.

Why we used a drone

The copper roof sits on the tower, above the rest of the building. To clean it by hand, someone has to stand on wet, sloped metal. A lift has to reach up and over the building. Copper is soft and shows every scuff, so the fewer feet and tools that touch it, the better.

The drone carries the spray head, and a hose feeds it from our ground equipment, so it does not run out of solution halfway across the roof. Nothing but the spray touches the metal.

See also: Drone cleaning service · Commercial roof cleaning

How the afternoon went

This was not the job we drove to Ohio for. We spent the morning cleaning the windows at 515 E Main St, a new office building in Columbus, and the distillery came up the same day.

We set up around 1 PM and were spraying 15 minutes later. We worked the roof one section at a time. After the first pass, bright copper was already showing through, and we finished the roof that afternoon.

The photo below is from the middle of the job, shot straight down from a second drone. The left side has not been washed yet. The right side has had one pass. The cleaning drone is at the bottom edge of the roof.

Overhead view of a copper roof mid-cleaning, dark oxidized panels on the left and bright copper on the right, with the cleaning drone at the roof edge
Mid-job, shot straight down. Left: not washed yet. Right: after one pass.

See also: The office windows we cleaned that morning

What a copper roof owner can choose

When a copper roof goes dark, there are three reasonable choices. One: clean it. The oxidation starts over, and the roof will darken again. Two: clean it and add a clear protective coating to slow that down. Three: leave it and wait for the green patina, which protects the metal and is the look many architects want.

Any of the three is fine. What matters is that nothing harsh enough to scratch or pit the metal touches it. Copper shows every mark.

Frequently Asked Questions

Ready to see what drone cleaning costs?

Free estimate in under 30 seconds.