In Philadelphia, spring exterior work runs in a set order. In March, check gutters and downspouts for winter damage. In early April, look for freeze-thaw cracks before anyone washes. In April, rinse road salt off the low parts of the house. Then wait for the tree pollen to pass and book the house wash for late May into June, with windows and hardscape after it.
Key Takeaways
- Check gutters and downspouts first: ice pulls hangers loose and splits seams over winter
- Find freeze-thaw cracks and loose mortar before the wash, so the crew can work around them
- Rinse road salt off steps, railings, and the lower walls in April
- Book the house wash for late May into June, after the tree pollen has dropped
- Clean top-down: gutters, roof, siding, windows, then decks, patios, and walks
What a Philadelphia Winter Leaves on a House
A winter here leaves three kinds of work on a house. Ice and wet leaves load the gutters. Freeze-thaw cycles open cracks in concrete, mortar, and caulk. Road salt splashes onto the steps, railings, and the lower few feet of the walls along the driveway and the street.
Then the pollen comes. Oaks, maples, and pines coat everything in yellow-green dust in April and May. That is why the order matters. Some spring jobs should happen early, and the house wash should wait.
This checklist is for spring only, and it is for a house. For the full year on a commercial property, see our seasonal calendar. For the jobs before winter, see the fall checklist.
See also: A Seasonal Exterior-Maintenance Calendar · A Fall Exterior-Maintenance Checklist
March: Check the Gutters After Winter
Start with the gutters, because they can damage the rest of the house while you wait. Do the check from the ground, on a rainy day if you can, when you can see the water move.
Sagging runs: ice adds a lot of weight to a gutter. A run that dips in the middle has usually lost a hanger.
Split seams and corners: look for drips at the joints during rain, or dark streaks on the siding under a seam.
Downspouts: water should come out the bottom at full flow. If the gutter overflows but the downspout is only trickling, the blockage is in the downspout.
Splash blocks and extensions: snow plows, shovels, and kids knock these out of place. Put them back so water goes away from the foundation.
Shingle granules: a lot of sandy grit at the downspout outlets can mean an older roof is shedding its granules. Mention it to a roofer.
One more spring point: maple seeds and oak tassels fall in April and May. On a lot with big maples or oaks, a gutter cleared in March can fill again by June. Check it once more after the tassels drop.
See also: How Often to Check Gutters Between Cleanings · Gutter cleaning
Early April: Find Freeze-Thaw Damage Before Anyone Washes
Water gets into small cracks, freezes, and opens them wider. After a few months of that, walk the house and look for damage before you book any washing.
Concrete steps and walks: look for flaking or pitted spots on the surface and for corners that have broken off.
Pavers and flagstone: look for stones that rock under your foot or sit higher than the stones next to them.
Brick and stone walls: look for mortar joints that are open, crumbly, or missing.
Caulk: check around windows, doors, and where pipes and wires go through the wall.
Tell the cleaning crew about all of it. Water forced into an open joint or a crack makes it worse. A good crew starts at low pressure on every surface and goes up to medium only if needed. High pressure is a last resort, because it can be destructive. On damaged spots they stay low or skip the spot, and some repairs should happen before the wash.
April: Rinse Off the Road Salt
Salt holds water against a surface, and it rusts steel and iron. In April, look at the parts of the house that sat near salted pavement all winter: the front steps, iron railings, the bottom of the garage door, and the lower walls along the driveway and the sidewalk.
On brick and concrete you may see a white, powdery crust. Some of it is road salt. Some of it is salt that water carries out of the masonry itself as it dries, called efflorescence. Both are worth rinsing off.
This is a quick rinse. Save the full house wash for later. Plain water at low pressure takes off most salt crust on steps and walks. Clean the railings too, and touch up any spots where the paint has chipped and rust has started.
Late April to May: Let the Pollen Pass
If you wash the siding in the middle of pollen season, the walls turn yellow-green again in a few weeks. The pollen film also holds moisture on the wall and feeds the algae that shows up later in the summer.
So in late April and May, the main job is to wait. Use the time to get quotes and book a date. Clean the screens if you want clear windows sooner, since screens hold pollen and let it run down onto the glass with every rain.
Our pollen guide explains where it collects on a house and why a rinse with a garden hose moves it around more than it takes it off.
Late May Into June: House Wash, Then Windows
Late May into June is the best time to wash a house in this area. The tree pollen is mostly down, and the humid summer has not yet fed new algae on the shaded walls.
We soft wash the siding. A cleaning solution goes on at low pressure, stays on the wall for a few minutes to kill the algae and mildew, and then we rinse it off from the top down. The solution also needs the air above about 45 degrees to work well, which is easy by late May.
Work from the top of the house down, so dirty runoff never lands on something already clean. Gutters come first, then the roof if it needs it, then the siding, then the windows. Windows go after the siding so runoff from the wall does not spot the clean glass.
If you want the whole list done in one visit, ask for it. One crew working top-down is the simplest way to keep the order right.
See also: Best Time to Pressure Wash a House · House washing · Window washing
Last: Decks, Patios, and Walks Before Summer
Hardscape goes last, because the runoff from everything above it lands there.
Look at the shaded parts first: the north side of the house, under trees, and the steps down from the deck. Green algae on a walk or a deck board is slippery when wet. Clear it before the first cookout.
Concrete and stone get a pressure wash with a surface cleaner, which keeps the spray under a hood and cleans evenly. Pressure starts low. Wood and composite decks need a lighter touch, because too much pressure tears up wood fibers and scars composite boards.
See also: How to Clear Algae From Shaded Walkways · Patio and walkway washing
What to Send With Your Quote Request
Your spring walk-around already did most of the work for a good quote. Send photos of the green walls, the gutter problems, and any damage you found in April. Tell us what the siding is, if you know, and point out anything we should not spray, like a cracked step or a loose stone.
We serve Philadelphia and the Main Line, and we quote within 24 hours. You can text a photo or call (610) 981-2285. After every job, the crew walks the property with you to make sure it is clean before we pack up.
See also: Request a quote
